Safety Devices & Remote Controls

1.IKA FK 1 Flexible Coupling

Required for stirring tasks using glass stirring rods. The flexible coupling compensates for any structural variances.

2.IKA R 301 Stirring Shaft Protection

Prevents potential injuries at the rotating shafts and stirring elements. Can be directly attached to the EUROSTARs, RW 16 basic, RW 28 basic and the RW 20 stirring motors.

3.IKA R 301.1 Support Holder For R 301

For fixing the stirring shaft protection R 301 to the stand.

4.IKA R 302 Stirring Shaft Protection

Prevents potential injuries due to the rotating shafts and stirring elements. Can be directly attached to the stirrer RW 47 D.

5.IKA RC 1 Remote Control

Remote control to operate the Eurostar power control visc (also P4 and P7) over a 10 m cable. - Provides problem-free control of stirrers even under load - Displays actual speed, target speed and overload status

6.IKA SI 472 Fixing Device

To attach the safety switch SI 400 to the floor stand R 472.

7.IKA SI 474 Fixing Device

To attach the safety switch SI 400 to the telescopic stand R 474.

8.IKA SI 400 Safety Switch

The SI 400 consists of an end switch (normally closed contact / switch) and a magnetic switch contact (actuator) which is mounted on the floor stand R 472 with the fixing device SI 472 and on the telescopic stand R 474 with the fixing device SI 474. The stirring unit RW 47 can only be switched on through the SI 400, when the agitator is adjusted in the mixing vessel to the user designated height. The power of the RW 47 automatically shuts off if the stirring unit is lifted off the designated height.